BeneVision TMS60, Operator'S Manual

Page: 57 / 250

Patient Management Placing a Device in Standby
TMS60 Operator’s Manual 5 - 3
5.4 Placing a Device in Standby
To enter the Standby mode:
1. In the main menu, tap Standby .
2. In the Standby confirmation menu, tap Yes .
Placing a device into Standby mode does the following:
■
Suspends patient monitoring
■
Alarm system is suspended
■ Removes all patient data from the screen and displays Standby Mode on the
screen.
■
The screen display automatically turns off after the device enters the Standby
mode for 30 seconds.
■
Notifies the CMS of the standby mode
5.5 Exiting the Standby Mode
Press to exit the standby mode.
After exiting the Standby mode, the system responds as follows:
■
Restores parameter measurement as previously configured.
■
Alarm system is activated.
■
Notifies the CMS of returning to normal monitoring.
NOTE
•
When the device is connected to the CMS, the patient category at the
CMS is updated if the patient category is changed at the TD60. Refer to
the
BeneVision Central Monitoring System Operator’s Manual for details.
NOTE
•
When connected to the CMS, and a device enters or exits Standby mode,
the CMS is also notified to enter or exit Standby mode. Refer to the
Ben-
eVision Central Monitoring System Operator’s Manual for details.