BENETEAU Oceanis 321, User Manual

Page: 28 / 127

03/02/07
23
9:08 AM
Rev. 05
1. Loosen the transmission to shaft coupling bolts enough to slide a feeler gauge between the
coupling plates.
2. Measure the gap all around the coupling to ensure the gap is constant.
3. If the gap varies, raise or lower the corners of the engine at the engine mounts until a constant gap
is achieved.
4. Re tighten the coupling bolts
Secure the yacht to a pier or dock with bow, stern, and spring lines and operate the engine
at low speeds in neutral, forward, and reverse. Check:
•
Throttle and shift controls
•
Engine operation
•
Alternator output
•
Water temperature (See engine owner's manual for operating temperature range).
•
Oil pressure (See engine manual).
•
Check the fuel system for leakage.
•
Re-check the propshaft seal for proper adjustment. Adjust if necessary. (See
propshaft seal manufactures instructions)
•
Install and check the operation of the emergency tiller.
10.3.4. Rigging and Sails
Check the following after mast is in place:
1. All standing rigging complete and in place, dockside tuning completed. (See section
13).
2. Mast boot installation completed.
3. All cotter pins in place and taped.
4. Running rigging in place.
5. Sails hoisted to check fit.