Operation Manual
EL320.240.36-HB Display
Beneq Oy
Olarinluoma 9
Tel. +358 9 7599 530
VAT ID FI19563372
FI-02200 Espoo
Fax +358 9 7599 5310
www.beneq.com
Finland
www.lumineq.com
Date: February 13, 2017
Document number: ED000812C
Page | 6
There is no overcurrent protection on either the V
H
or V
L
inputs to protect against
catastrophic faults. Beneq recommends the use of a series fuse on the 12 volt supply (V
H
). A
general guideline is to rate the fuse at 1.8 to 2 times the display maximum current rating.
3.3
Connector
The display uses the Samtec EHT-110-01-S-D or equivalent locking connector. The mating
connector is in the Samtec TCSD family of cable strips. The proper connector, user-specified
cable length and connector configuration is supplied as a single unit. Consult your Samtec
representative for the cable/connector options. Compatibility with non-Samtec equivalents
should be verified before use.
Figure 1. Data/power connector
Table 3. J1 Connector pinouts
Pin
Signal
Description
Pin
Signal
Description
1
V
H
+12 V Power
2
V
H
+12 V Power
3
Self-test
Self-test Input
1
4
SCAN
Scan rate control
5
V
L
+5 V Power
6
GND
Ground
7
VS
Vertical Sync
8
GND
Ground
9
HS
Horizontal Sync
10
GND
Ground
11
VCLK
Video Clock
12
GND
Ground
13
VID
0
Video Data
14
GND
Ground
15
VID
1
Video Data
16
GND
Ground
17
VID
2
Video Data
18
GND
Ground
19
VID
3
Video Data
20
GND
Ground
1
Connect pin 3 to ground for normal display operation.
J1
J2
Pin 1
Pin 1
Key
Pin 2
Pin 1
Key
(Viewed from top of connector)
(Viewed from back of display)
