Benefon EXION TDP80DN, Service Manual

Page: 21 / 63

11.10.2001
6DP_80GB.fm 9
Product: TDP80DN / Installation Instructions
3.2.4 Button Unit
The button unit enables easy operation of the Car Kit. The unit consists of
plastic base and buttons. Decide where to install the buttons unit. Possible
locations are on the dashboard or on the handbrake lever. Mount the plastic
base using supplied screws, bands or adhesive tape. Attach the buttons to the
base. Make sure the plastic snaps are locked.
Note: The unit can be mounted without the plastic base
3.2.5 Car Box UBH75
Place the car box out of sight inside the dashboard of the car or in another
suitable place.
If required, attach the unit to the car interior using 4 screws (not supplied).
3.2.6 Hf Speaker
Install the speaker in a suitable place near the floor of the car. The loudspeaker
should be located at least 90 cm from the microphone. Mount the loudspeaker
using the supplied bracket and screws.
Note: It is possible to use the front right-side car’s loudspeaker instead of a
dedicated loudspeaker.
3.2.7 Installation Material Bag
The installation material bag contains the standard installation equipment. You
may not need everything in the bag.
3.3 Operation and Testing after Installation
Once completing the installation, perform the following tests:
1. Connect all cables, except for the power cable, to the car box.
2. Make sure there is no phone connected in the hf holder.
3. Connect the power cable to the car box.
4. Turn on the ignition key (no need to start the engine).
5. After few seconds a short beep will be heard from the loudspeaker, signaling
that the system is operating.
6. Place the phone in the hf holder and connect it. A double beep should be
heard, and both LED's on the button unit will light.
7. Record (long press on the Green Button of the button unit) and playback
(Long Press on the Red button of the button unit and then long press on the
Green button of the button unit) to ensure that the microphone is installed
correctly.