10. Install the lid on the box. Bend the wicks
CAREFULLY
to the side of the
FAN
to ensure laying
PARALLEL
on the bottom of the housing.
The proper installation can be seen on the picture below. Shown at a transparent plastic housing.
11. Tape two rubber feet on the
EXIT
side of the
housing.
The exit side should be raised slightly to keep the
smoke oil more in the opposite edge.
12. Insert the filling tube.
Make sure it last about
5mm until bottom
End of filling tube
2x Elevation feet on filling tube side
ONLY
Final installation with fixed outlet and refill tubes, using three cable ties.