Large front wheel
Large front wheel is designed for physical activities in broken terrain and sport activities such as "in-line"
skating, hiking or "jogging". Large front wheel is firmly fixed in a given position, the stroller keeps a track
and is not turning. With the help of two inner clamps (Fig. 2) the stroller may be positioned according to
your needs and required sway. The position of the child can be than easily changed from a sitting position
(Fig. 3) to the lying position (Fig. 4).
The front wheel sleeve must always be held behind its axis.
Maintenance of the front wheels rests in inflating the tires, up to a maximum given pressure.
Pull system for a wheel with a shield
Pulling system (Fig. 5) is used for cycling. It consists of a drawbar with a protective shield and fixing. The
cycling set is always supplied with 2 pieces of fixing. Instal the pulling system below the axis nut of the rear
wheel or below the locking lever of the quick release hub of the rear wheel (opposite the front derailleur).
While installing grasp the beginning of the drawbar, insert it into the fixing, thread the fuse through both
the drawbar and the fixing and wrap it by the retaining strap ( Figure 6). To connect the tow bar any
specific angle between the wheel and drawbar is not necessary, which allows you to position the stroller
according to your needs.
The shield positioned on the drawbar prevents small stones and other debris flying off the wheel to harm
the child sitting in the stroller. Put the shield into the hole approximately in the middle of the drawbar,
then fasten with clamp. For the right effect of the shield pay attention to keeping the shield in a position
with regard of the rear wheel and the stroller (Fig. 7)
.
2
2
3
4
