BENECOM BEM-100BYT2, User Manual

Page: 58 / 118

BEM-100BYT2 User’s Manual
58 BEM-100BYT2 User’s Manual
onto 1 or or more bytes.
Bits per second
9600
19200
38400
57600
115200
[Default]
Select serial port transmission speed. The
speed must be matched on the other side,
Long or noisy lines may require lower
speeds.
Data Bits
7
8
[Default]
Data Bits.
Parity
None
[Default]
Even
Odd
Mark
Space
A parity bit can be sent with the data bits to
detect some transmission errors. Even:
parity bit is 0 if the num of 1’s in the data
bits is even. Odd: parity bit is 0 if num of 1’s
in the data bits is odd. Mark: parity bit is
always 1. Space: Parity bit is always 0.
Mark and Space Parity do not allow for
error detection. They can be used as an
additional data bit.
Stop Bits
1
[Default]
2
Stop bits indicate the end of a serial data
packet. (A start bit indicates the beginning).
The standard setting is 1 stop bit.
Communication with slow devices may
require more than 1 stop bit.
Flow Control
None
[Default]
Hardware RTS/CTS
Flow control can prevent data loss from
buffer overflow. When sending data, if the
receiving buffers are full, a ‘stop’ signal can
be sent to stop the data flow. Once the
buffers are empty, a ‘start’ signal can be
sent to re-start the flow. Hardware flow
control uses two wires to send start/stop
signals.
VT-UTF8 Combo Key Support
Disabled
Enabled
[Default]
Enable VT-UTF8 Combination Key Support
for ANSI/VT100 terminals.
Recorder Mode
Disabled
[Default]
Enabled
With this mode enabled only text will be
sent. This is to capture Terminal data.
Resolution 100x31
Disabled
[Default]
Enabled
Enables or disables extended terminal
resolution.
Legacy OS Redirection
Resolution
80x24
[Default]
80x25
On Legacy OS, the Number of Rows and
Columns supported redirection.
Putty KeyPad
VT100
[Default]
LINUX
XTERMR6
SCO
ESCN
VT400
Select FunctionKey and KeyPad on Putty.
Redirection After BIOS POST
Always Enable
[Default]
BootLoader
The Settings specify if BootLoader is
selected then Legacy console redirection is
disabled before booting to Legacy OS.
Default value is Always Enable which
means Legacy console Redirection is
enabled for Legacy OS.