BendPak TS-580V-601, Installation And Operation Manual, Page: 11 / 20

11
AIR FILTER
Never run the compressor pump without an intake air filter
or with a clogged intake air filter(s). Use compressed air to
blow the filters clean. Do not wash or oil the element. If it
cannot be blown clean, the filter(s) must be replaced.
Operating compressor with a dirty filter can cause high oil
consumption and increase oil contamination in the discharge air.
INTERCOOLER TUBING
Intercooler fins are very sharp. Always wear gloves and use
care when you clean or work near the intercooler
tubing. Weekly, check the intercooler to be sure all fittings
are secure and tight. Blow all dirt, dust and other
accumulations from the intercooler fins.
COMPONENTS
Turn off all power and use light air pressure to blow
dust and foreign material from cylinder head, motor, fan
blades, air lines, intercooler and tank on a monthly basis.
When using an air blow gun always wear
eye protection and face mask/respirator. Fast
moving air will stir up dust and debris which
may be harmful.
BELTS
The v-belt(s) should be adjusted so that a declination of
about 3/8 – 1/2 inch will be obtained when it is pushed by a
finger at the middle point as shown.
Over tightening the v-belt(s) will result in overloading
of the motor and belt failure, while a loose belt will be
slipping and resulting in an unstable speed, vibration,
overheating the belt and high amp draw. To change tension,
loosen the motor hold-down bolts and slide the motor on the
base, using a lever if necessary, or by turning the adjusting
bolt at the end of the base. Retighten motor hold-down bolts.
NOTE: DO NOT OVER TIGHTEN BELTS.
Also, align belts using a straight edge against the face of the
flywheel and touching the rim on both sides of the face. The
belts should be parallel to this straight edge. Dimension A
should be the same as B and C to ensure proper alignment
of the belts. Slots in the bed-plate allow for sliding the motor
back and forth to adjust belt tension.
TROUBLESHOOTING