35
• DAILY
inspect your lift. Never operate if it malfunctions
or if it has broken or damaged parts. Use only qualified lift
service personnel and genuine BendPak parts to make
repairs.
• THOROUGHLY
train all employees in use and care of
lift, using manufacturer’s instructions and “Lifting It Right”
and “Safety Tips” supplied with the lift.
• NEVER
allow unauthorized or untrained persons to
position vehicle or operate lift.
• PROHIBIT
unauthorized persons from being in shop
area while lift is in use.
• DO NOT
permit anyone on lift or inside vehicle when it is
either being raised or lowered.
• ALWAYS
keep area around lift free of tools, debris,
grease and oil.
• NEVER
overload lift. Capacity of lift is shown on
nameplate affixed to the lift.
• DO NOT
stand in front of the vehicle while it is being
positioned in lift bay.
• DO NOT
block open or override self-closing lift controls;
they are designed to return to the “Off” or Neutral position
when released.
• ALWAYS
remain clear of lift when raising or lowering
vehicles.
• ALWAYS
use safety stands when removing or installing
heavy components.
• DO NOT
go under raised vehicle if safety locks are not
engaged.
•
NEVER LEAVE LIFT IN ELEVATED CONDITION
unless all Safety Locks are engaged.
• AVOID
excessive rocking of vehicle while on lift.
• ALWAYS CLEAR AREA
if vehicle is in danger of falling.
• ALWAYS REMOVE
tool trays, stands, etc. before lower-
ing lift.
• ALWAYS RELEASE
safety locks before attempting to
lower lift.
•
DO NOT
position yourself between a wall and the lift.
If the vehicle falls in that direction, you may be severely
injured or killed.
To Raise Lift;
1. Position vehicle tires in the center of each Runway.
2. Set parking brake and use Wheel Chocks to hold
vehicle in position.
3. Before raising vehicle, be sure all personnel are clear
of the lift and surrounding area. Pay careful attention to
overhead clearances.
4. Raise the lift to the desired height by pressing the
push button on the power unit.
5. After vehicle is raised to the desired height, lower the
lift onto the nearest Safety Lock. Do not allow Cables to
become slack. ALWAYS ENSURE ALL SAFETY LOCKS
ARE ENGAGED before entering work area.
NOTE:
ALLOW (2) SECONDS BETWEEN MOTOR STARTS.
FAILURE TO COMPLY MAY CAUSE MOTOR BURNOUT.
DANGER!
VISUALLY CONFIRM THAT ALL PRIMARY SAFETY
LOCKS ARE ENGAGED BEFORE ENTERING WORK
AREA. SUSPENSION COMPONENTS USED ON
THIS LIFT ARE INTENDED TO RAISE AND LOWER
LIFT ONLY AND ARE NOT MEANT TO BE LOAD
HOLDING DEVICES. REMAIN CLEAR OF ELEVATED
LIFT UNLESS VISUAL CONFIRMATION IS MADE
THAT ALL PRIMARY SAFETY LOCKS ARE FULLY
ENGAGED AND THE LIFT IS LOWERED ONTO
THE SAFETY LOCKS, REFER TO INSTALLATION/
OPERATION MANUAL FOR PROPER SAFETY LOCK
PROCEDURES AND/OR FURTHER INSTRUCTION.
Summary of Contents for HD-7500BL
Page 29: ...29 ...
Page 38: ...38 ...
Page 39: ...39 ...
Page 48: ...48 ...
