BendPak 5175004, Service Manual, Page: 27 / 35

2
9
8
4
3
5
1
7
10
6
11
12
ISOMETRIC VIEW
FOR REFERENCE ONLY
DO NOT SCALE
ITEM NO PART NUMBER DESCRIPTION QTY REV
1 5766432 D4-12, HD-14 CROSSTUBE, LARGE WINDOW 1 A
2 5735027 CROSSTUBE SAFETY BLOCK 2 B
3 5755168 AIR LINE TROUGH Ø13.5 x Ø9.5 x 2050 1 A
4 5755022 AIR LINE TROUGH Ø13.5 x Ø9.5 x 121 2 B
5 5735023 HD-14 SERIES TOP CROSS TUBE STRAP 1 D
6 5735039 HD/HDSO-14 BOTTOM CROSS TUBE STRAP 1 D
7 5620190 HD-14 CROSSTUBE END PLATE SUBWELDMENT #1 1 G
8 5620191 HD-14 CROSSTUBE END PLATE SUBWELDMENT #2 1 G
9 5620192 HD-14 CROSSTUBE END PLATE SUBWELDMENT #3 1 F
10 5620193 HD-14 CROSSTUBE END PLATE SUBWELDMENT #4 1 G
11 5760003 D4-12, HD-12/14 RAMP STOP 1 C
12 5735073
D4-12, HD-7/9, HDS/HDSO-14 CARRIAGE TIE
BLOCK
2 C
NEXT ASSEMBLY
5216145
WHERE USED
HD-14T
REVISION
REV DESCRIPTION DATE EDITED BY ECO#
A PRODUCTION RELEASE, DERIVED FROM 5600058 04/28/2022 TM 01414
SHEET 1 OF 3
REV DWG. NO.
A
SIZE
TITLE:
NAME DATE
CHECKED
DRAWN
A
1645 LEMONWOOD DR.
SANTA PAULA, CA 93060
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS DRAWING IS
THE SOLE PROPERTY OF BENDPAK INC. ANY
REPRODUCTION IN PART OR AS A WHOLE WITHOUT
THE WRITTEN PERMISSION OF BENDPAK INC. IS
PROHIBITED.
TM
5601806
HD-14 CROSSTUBE
WELDMENT, LARGE WINDOW
04/28/2022
DO NOT SCALE DRAWING
1:20 SCALE:
THIRD ANGLE PROJECTION
DIMENSIONS ARE IN MM
TOLERANCES:
0. = ±1.5
0.0 = ±0.5
SURFACE FINISH 1.6 ISO Ra µm
FOR MACHINED SURFACES
UNLESS OTHERWISE SPECIFIED
REFER TO MODEL FOR ADDITIONAL INFORMATION 1.
BREAK AND DEBURR ALL SHARP EDGES 0.3mm 2.
REMOVE ALL WELD SPLATTER 3.
DIMENSIONS SHOWN ARE AFTER PAINTING 4.
PAINT GRAY (RAL-7024) 20% GLOSS 5.
NOTE: UNLESS OTHERWISE SPECIFIED.