31
Additional Operational Notes
Adjusting the Alert Volume
The Bendix
®
Wingman
®
Fusion
™
system audible alerts are pre‑set at the
factory for fully integrated systems and cannot be turned off by the driver,
but, depending on the OE, the volume may adjustable.
For systems using a Bendix
®
Driver Interface Unit (DIU
™
) display, see
Bendix
Wingman Fusion Service Data sheet SD-61-4962
for information about volume
adjustment.
Temporarily Disable the Lane Departure Warning (LDW)
To avoid erroneous LDW warnings in areas such as construction zones – where
the non‑standard or overlapping road markings present might cause false
alerts – the Wingman Fusion system has an enable/disable switch. Each OEM
typically has a different arrangement to allow the driver to temporarily disable
the Lane Departure Warning (LDW) system and to display the system status.
Refer to the OEM Operator’s Manual for any system indicator lamp(s). See
below for some examples of OEM icons used at the time this document was
published.
Dash/Switch Icon.
(The design will vary by vehicle
OEM. In some cases, the
switch and lamps may be
separate.)
International
®
Kenworth
®
Mack
®
Peterbilt
®
Volvo
®
* All trademarks shown here are the property of their respective owners and are used for reference only.
Event Capture
In the case of vehicles configured to do so, the enable/disable switch used
by the LDW system also functions – when depressed for six (6) seconds – to
activate a request from the SafetyDirect
®
by Bendix CVS Processor to the
On Board Computer (OBC)/Telematics system to transmit ten seconds of
video data – the five (5) seconds before, and five (5) after the button was
pressed). In some cases, more video data may be available using the Bendix
SafetyDirect Client.
Summary of Contents for Wingman Fusion
Page 38: ...38...
