28
Water drainage
This appliance is designed to be permanently plumbed
into your home's water supply and drainage system.
The appliance drain hose should hook (use the plastic
“U-piece” supplied) into a standpipe with an internal
diameter of approximately 38mm (see diagram) thus
ensuring there is an air break between the drain hose
and standpipe.
When discharging into a standpipe ensure that the top of
the curve in the hose end is no more than 90cm (35.4'')
and no less than 60cm (23.6'') above floor level. The
upright standpipe should have a minimum length of
30cm (12'') from the bottom of the elbow to the top of
the pipe (see diagram).
Make sure that it is designed in such a way, that the end
of the drain hose cannot be covered with water.
The drain hose may be extended to a maximum of 3
metres. An additional drain hose and joining piece is
available from your local Service Force Centre.
The joining piece must have an internal diameter of
18mm.
If you intend the drain hose to empty into a sink, make
sure that the sink is empty and the plug hose is not
blocked. Use the plastic “U-piece” supplied.
P0022
P1040
Min.
30 cm.(12")
38 mm.(1/ ") diameter
standpipe
1
2
P1039
3 pin
Max.
90 cm.(35.4")
Min.60 cm.
(23.6")
Summary of Contents for BIW 102
Page 1: ...OPERATING INSTALLATION INSTRUCTIONS WASHING MACHINE BIW 102 35 292 687 1...
Page 2: ......
Page 31: ......
