Bender ATICS Series, Manual

Page: 56 / 104

56 ATICS-DIO_D00080_03_M_XXEN / 04.2021
Operation
Select a channel:
1. Use the " " arrow button to go to the channel settings. Press the " " button.
2. Use the arrow buttons to select the channel for which the alarm message is to be simulated.
Press the " " button to confirm your selection.
The alarm status will change from (no alarm) to (alarm). If the alarm status is not displayed,
the settings made for ATICS® will not permit simulation of this alarm.
Example of an alarm simulation: "Channel 5: MANUAL MODE“ is selected.
i
The ATICS® stays in this menu until it is exited by pressing the "ESC" button. During this time, all the
alarms on the BMS bus have the word "TEST".
Only the alarm messages listed in the following table can be simulated: „5.1.2 ATICS® messages on
the BMS bus (channel use)“ on p. 44.
6.2.4 Reset function
A RESET is used to reset the alarm and fault messages for the device as well as to disable the switch-
back lock of the changeover function. There are several ways to call up the reset menu:
• Select standard display and then press the "RESET" button on the front panel of the device for
at least one second.
• Select the "RESET" function from the Control menu. Reset menu:
Menu item Function Page
1. Alarm Reset alarm and fault messages on the device. P. 57
2. SwitchBack-
Lock Disable the switch-back lock of the changeover function. The device switches
back to the preferred line. P. 57
3. Changeover Change alarm value for the:
- Maximum number of changeover operations performed
- Maximum number of operating hours
- Maximum number of changeover operations performed which were carried out
with overcurrent or short-circuit current P. 57
Manual mode: --
Exit
Channel: 5 MODE
Channel disabled
Exit
Channel: --
Exit
1. Alarm
2. SwitchBackLock
3. Changeover