Figure 2 - On the main board, move jumper on P1 to this position.
Figure 3 - Finished installation. White line on software chip must face the rear of the unit!
Page 1: ...A4 REMOTE menu Enabling and disabling the COMPATIBILITY mode Simultaneously hold the DIM MUTE and INPUT UP keys for 3 seconds to activate or deactivate this feature The HT light will be illuminated on all inputs when COMPATIBILITY mode is enabled The DIM MUTE key will be disabled when COMPATIBILITY mode is enabled The DAC3 will not respond to the DIM MUTE VOLUME UP and VOLUME DOWN keys on the IR r...
Page 2: ...d backwards 8 Replace the top cover 9 Turn the unit on The A2 light should flash rapidly while the unit is turning on This indicates that Version 2 0 is installed Reverting back old software If you wish to revert back to the old software the entire kit can be removed see Figure 1 but this is not really necessary The software chip and the jumper on the back of the control board can be left in place...
Page 3: ...Figure 1 Top view before installing software kit note the position of jumper on header P1 ...
Page 4: ...Figure 2 On the main board move jumper on P1 to this position Figure 3 Finished installation White line on software chip must face the rear of the unit ...
