Page 7
7. Install the (8) leveling screws.
Fully thread a 1/4" hex nut on each of the (8) 1/4-20 x 3/4" socket
head cap screws. Install these bolt assemblies into the (8)
leveling holes in the insert brackets. DO NOT use the two insert
plate attachment holes. These holes have protruding round nuts
on the underside of the insert brackets. You will adjust these
leveling screws in step 13.
8. Attach routertop to cabinet asssembly.
Attach using 1/4-20 x 1-3/4" flat head socket cap screws and
1/4-20 cross dowels. Do not fully tighten at this time.
9. Connect insert brackets to the back panel.
Attach using 1/4-20 x 1-1/4" button head screws and 1/4" nylon
insert lock nuts, as shown. Locate the nuts to the inside of the
cabinet. Do not fully tighten at this time.
10. Attach the miter track to routertop.
Use (2) 1/4-20 x 5/8" flat head socket cap screws and 1/4" nylon
insert lock nuts to fasten the miter track to the insert brackets.
Use (2) 1/4-20 x 1-1/4" flat head socket cap screws and 1/4-20
cross dowels to fasten the miter track to the cabinet side panels.
Eliminate any gap between the miter track and routertop before
tightening the bolts.
7
8
9
10
1/4"
hex nut
1/4-20 x 3/4"
socket head
cap screw
1/4-20 x 1-3/4"
flat head socket
cap screw
1/4-20 x 1-1/4"
button head
socket cap screw
1/4-20 x 5/8"
flat head socket
cap screws
1/4-20
cross dowel
nylon insert
lock nut
nylon insert
lock nut
1/4-20
cross dowel
1/4-20 x 1-1/4"
flat head socket
cap screws.
insert plate
attachment
hole
