9
STEP 3 :
Slide the quick release (QR) into the wheel hub. Check that
the QR lever is on the side opposite the derailleur (see rear
wheel). Slide on one of the two springs before screwing the
nut clockwise. Make sure that during this maneuver, the QR
lever is in the open position.
STEP 4 :
Finish screwing the nut, while closing the SR lever. Then
close it completely by pointing it towards the back of the
bike.
You should feel a clamping pressure when the QR lever is closed. The degree of quick-tightening can be ad-
justed by turning the nut when the lever is open: turn it clockwise to tighten or counter-clockwise to release
the pressure.
Check that the front wheel is correctly installed once the QR is closed. Raise the handlebars and try to move
the front wheel side to side and up and down. If there is no unwanted movement and if the wheel is well cen-
tered in the fork, the wheel is correctly mounted.
ATTENTION !
!
Before
Quick releases
Back
