Resetting the Thermal Cut Out
R33 The appliance is fitted with an Electronic Safety Control (E.S.). This is a safety
device, which switches off the fire if, for any reason, the appliance overheats, e.g.
when covered.
If the heater stops operating while the flame effect continues working normally, this
indicates that the E.S. Control is in operation. The E.S. Control can only be re-set after
the appliance has cooled down, and the appliance has been reset. Re-setting of the
E.S. Control proceeds is as follows:
R34 Switch off the appliance (Manual On / Off switch) and unplug it from the wall
socket or remove the fuse from spur if hard wired, leave it off for approximately 10-15
minutes.
R35 Remove any obstruction to the fan heater outlet or fan blades etc. Make sure that
the power supply is disconnected with the plug socket outlet while doing this.
R36 Switch on the appliance and the E.S. Control will be re-set.
R37 Ensure that the appliance is functioning correctly. If the E.S. Control operates
again, the appliance should be checked by a competent electrician.
CAUTION:
In order to avoid a hazard due to inadvertent resetting of the thermal cut
out, this appliance
must not be
supplied through an external switching device, such as
a timer, or connected to a circuit that is regularly switched on and off by the utility.
WARNING: Before undertaking any maintenance or cleaning disconnect your
appliance from mains supply and ensure it is completely cool.
Only competent persons should service / repair these appliances.
Remote Handset Battery Replacement
• When the batteries are at full power, the battery symbol will show
• When the batteries are half full, the battery symbol will show
• When the batteries are out of power and need replacing immediately, the battery
symbol will show
• Battery replacement is recommended after 1 year. The batteries are 1.5V alkaline
AAA, batteries.
• Dispose of old batteries at an appropriate recycling facility.
