10
Removal of the front glass panel.
The top glass clamp is held in place with 3 screws. This
panel is concealed behind the top cover strip which is held
in place by two magnets. The two magnets are fitted to the
top glass clamp as shown in this diagram.
Carefully remove the 3 fixing screws and whilst supporting
the glass panel, remove the clamp. Now lift the glass from
the appliance. The bottom edge of the glass is retained in
the two supports bottom left and right.
Now the ceramics can be installed, rearranged correctly or
removed for service. Correct installation of ceramics see
pages 17—23.
Installation of the front glass panel.
Before replacing the glass ensure that the seal around the top
and two sides of the firebox is in good condition and is
securely affixed to the appliance. If the seal is damaged or
loose then it should be replaced / reaffixed before the glass is
replaced. This seal is important and if damaged, the appliance
should not be operated.
The glass panel should be undamaged. If the glass panel is
broken or cracked it should not be used. Contact the
manufacturer for a suitable replacement before continuing.
Replace the glass panel into position by locating the bottom
edge into the two lower supports., and securing the top edge
with the top clamp. The top clamp is secured with three (3)
fixing screws (as detailed above).
Ensuring the two magnets are in the correct position (see
above) then the top cover can be placed into position. This
component is purely decorative and is used to conceal the
top clamp fixing structure.
