or press the - key to delete a day.
·
Press the TIMER SET key to set the on time. The hour digit starts blinking.
·
Press the + or – key to set the hour.
·
Press the TIMER SET key. The minute digit starts blinking.
·
Press the + or – key to set the minute.
·
Press the TIMER SET key to set the off time. The hour digit starts blinking.
·
Press the + or – key to set the hour.
·
Press the TIMER SET key. The minute digit starts blinking.
·
Press the + or – key to set the minute.
·
Press the TIMER SET key. The temperature digit starts blinking.
·
Press the + or – key to set the temperature.
·
Press the TIMER SET key to continue with the timer setting or press the OK key to confirm the setting.
▪
Viewing the timer setting
·
Press the TIMER SET key.
·
Press the + or – key to check the power-on time of the set timers one by one.
·
To check the power-off time, press the
▲
key.
·
Press the + or – key to check the power-off time of the set timers one by one.
·
To delete selected setting, press the C key.
▪
Activation timer
·
Press the TIMER ON / OFF key to activate the timer function.
·
NOTE:
When the timer is active, the heating level must be manually selected. If the heater function is not
selected; only the flame effect goes on at the set power-on time.
▪
Automatic heating mode
·
Press the IC key to activate automatic heating mode. The AUTO icon appears on the display.
·
When the automatic heating is turned on, the heater automatically
changes the heating level depending on the set
temperature and the ambient room tempera
ture
Maintenance
·
WARNING
: Before any maintenance and/or cleaning the exterior of the heater, disconnect the heater form the
power supply and leave heater cooled off.
·
The heater uses an electronically controlled LED system to create the flame effect therefore no parts need to be
replaced. There are no user-serviceable parts on this heater. Under no circumstances should the heater be serviced
by any one other than a qualified electrician.
Safety Cut-out
·
This heater is fitted with a safety cut-out which will operate if the fire overheats (e.g. Due to blocked air vents).
For safety reasons, the heater will NOT automatically reset.
·
To reset the heater, disconnect the heater from the mains supply for at least 15 minutes. Check vents for
blockages reconnect the supply to the mains and switch on the heater.
Care and Cleaning
·
Always disconnect the heater from mains supply and allow cooling before any cleaning operation.
·
Trim parts may be cleaned using a clean, damp cloth. Never use abrasive cleaners and chemical agents as damage
