200781_1
16
Resetting the Thermal Cut Out
R31 This appliance is fitted with an Electronic Safety Control (E.S.). This is a safety device,
which switches off the fire if, for any reason, the appliance overheats, e.g. when covered.
If the heater stops operating while the flame effect continues working normally, this indicates
that the E.S. Control is in operation. The E.S. Control can only be re-set after the appliance
has cooled down, and the appliance has been reset. Re-setting of the E.S. Control proceeds
is as follows:
R32 Switch off the appliance (Manual On / Off switch) and leave it off for approximately 10-15
minutes.
R33 Remove any obstruction to the fan heater outlet or fan blades etc. Make sure that the
power supply is disconnected with the plug socket outlet while doing this.
R34 Switch on the appliance and the E.S. Control will be re-set.
R35 Ensure that the appliance is functioning correctly. If the E.S. Control operates again, the
appliance should be checked by a competent electrician.
WARNING: Before undertaking any maintenance or cleaning disconnect your appliance
from mains supply and ensure it is completely cool.
Only competent persons should service / repair this appliance.
Remote Handset Battery Replacement
When the batteries are at full power, the battery symbol will show
When the batteries are half full, the battery symbol will show
When the batteries are out of power and need replacing immediately, the battery
symbol will show
Battery replacement is recommended after 1 year. The batteries are 1.5V alkaline
AAA, batteries.
Dispose of old batteries at an appropriate recycling facility.
It may be necessary to set up the communication between the remote and the
appliance after the batteries have been replaced. See R29.
