200662_2
Page 3
.
Operation
This appliance can be operated by both remote control and manual button. Once the unit has been properly connected to an earthed electrical
outlet, turn on the main switch located on the right hand side of the appliance. A beep should be heard when the power is first applied.
CAUTION! The unit’s power cord must be connected to a properly grounded and
protected 220-240V outlet. Always use ground fault protection where
required by the electrical code.
WARNING! Do not operate the unit if it is damaged or has malfunctioned. If you
suspect the unit is damaged, please call a qualified service technician to
inspect and to replace any part of the electrical system if necessary.
NOTE! To use both remote and manual functions the manual on/off switch must be in ‘ON’
position.
Remote control
•
Ensure that the master on switch (Left hand side) is set to the on (I) position.
•
Press the “POWER / FLAME” Button, this turns the flame effect on.
•
Pressing the “LOW” button activates the 1KW heat setting, pressing the “LOW”
button again turns off the heating*. To increase the heat output the “HIGH” button
can be pressed to activate the 2Kw output setting.
•
Pressing the “HIGH” button activates the 2KW Heat setting, repressing the “HIGH”
button turns off the heating*. To decrease the heat output the “LOW” button can be
pressed to activate the 1Kw output setting.
•
When the heater is turned on there will be a brief period (aprox 6 secs) where the
heater will blow cold air. This is to clear the elements of any debris (Dust, Hair etc)
that may have collected on the element. Similarly once the heater is switched off
the fan will blow cold air through the elements ensuring that the elements re cooled
before turning off the fan
Manual Control
The Manual controls for the fire are located on the right hand side of the fire unit. The controls are FLAME, HEATER, THERMOSTAT and the
MASTER ON AND OFF SWITCH.
