200688_6
Page
4
1 Piece trim (4 sided)
Using 4 of the 7mm magnets supplied, double them up to make two sets of 14mm magnets. Position the two 14mm magnets as shown in
FIG.8
close to the inside edge of the trim. Hook the top bracket over the top of the fire front and gently lower the trim into position, ensuring the trim does
not slip with the pull of the magnets. The trim installation is now complete.
Fig.8
Preparation for Use
Check that the supply voltage details on your flame effect fire are in accordance with your electrical supply. Your fire is fitted with a plug
incorporating a 13 Amp fuse. In the event of replacing the fuse in the plug supplied, a 13 Amp fuse approved by ASTA to BS 1362 must be used.
Before switching on, please read the following operation instructions.
.
Thermostat
This model is fitted with a thermostat that is mounted on the left-hand side of the heater box control panel (see figure 4).
It can be used to control the heat output to maintain a constant room temperature to suit user requirements. This will ensure that excessive heat is
not produced unnecessarily.
To set the temperature
The knob is marked with numbers to indicate the maximum and minimum temperature positions. Start with setting 9 and when the room has
reached a desired level turn the knob slowly to the left until the thermostat just ‘clicks’ off. The thermostat will then maintain the room temperature at
the selected level. To increase the temperature, turn knob back to the right to a higher setting.
Note: - It is possible that if the room temperature is higher than the thermostat setting it will not come into operation and the heater will
remain off until the temperature of the room cools.
Manual 3 Switch Operation
:
The Flame effect and heat controls are located under the top shelf of the
fire surround on the right-hand side of the heater box as shown in
Fig.9
.
•
The first switch marked with a light bulb controls the lamp and flame effect as shown in
Fig.10
.
•
The next two switches operate the fan convector heater. To use the heater the middle of the three switches marked
O/I
(
O
is off,
I
is on)
should be operated first for 1 kW of heat. The right hand switch also marked
O/I
should be used together with the middle switch to give
2kW of heat.
•
Note’ lamp’ switch must be in the ‘on’ position for heater to function.
Fig.9
Fig.10
