The product adopts microwave LED
sensor
mould
with
high-frequency
electro-magnetic
wave
(5.8GHz),
integrated circuit SMD LED. It gathers automatism,
convenience, safety, saving-energy and practicality
functions. The wide detection field is consisting of
detectors. It works by receiving human motion. When one enters the detection field, it can start
the load at once and identify automatically day and night. Its installation is very convenient and
its using is very wide. Detection is possible through doors, panes of glass or thin walls.
SPECIFICATION:
Power Sourcing: 110-240V/AC Detection Range: 360°
Power Frequency: 50/60Hz Detection Distance: 1-8m (radius) adjustable
Ambient Light:
：
<3-2000LUX (adjustable) HF System: 5.8GHz CW radar, ISM band
Time-Delay: min.:10sec±3sec Transmission Power: <10mW
Max.:12min±1min Installing Height: 2~4m
Rated Load: 10W (160PCS SMD LED) Power Consumption: approx 0.9W
Detection Motion Speed: 0.6~1.5m/s
FUNCTION:
Can identify day and night: It can work in the daytime and at night when it is adjusted to the
“sun” position (max). It can work in the ambient light less than 3LUX when it is adjusted to
the “moon” position (min). As for the adjustment pattern, please refer to the testing pattern.
SENS adjustable: It can be adjusted according to using location; low sensitivity with 2m for
detection distance; High sensitivity with 16m, it fits for large room.
Time-Delay is added continually: When it receives the second induction signal after the first
induction, it will compute time once more on the basic of the first time-delay rest.
Time–Delay is adjustable. It can be set according to the consumer’s desire. The minimum
time is 10sec±3sec. The maximum is 12min±1min.
NOTE: the high-frequency output of the HF
sensor is <10Mw- that is just one 100
th
of the
transmission
power of a mobile phone or the
output of a microwave oven, the baby can't
touch it
INSTALLATION: (see the diagram)
Switch off the power.
Turn the plastic cover anti-clockwise to open it
Put the wire through the rubber band which is at the bottom pan of light, and connect the
wire with terminal according to connect-wire figure.
Fix the base on the ceiling through the holes on the bottom pan with enclosed inflated
screws
Switch on the power and test it.
CONNECTION-WIER SKETCH DIAGRAM
Connecting the power source into the ”N” , ”L” according to connection wire diagram when you
install it.
TEST:
Turn the SENS knob clockwise on the maximum. Turn the
TIME knob anti-clockwise on the minimum, Turn the LUX
knob clockwise on the maximum (sun).
When you switch on the power, the light will be on at once,
and 5-30 seconds later will be off automatically. Then if
the light receives induction signal, it can work normally.
After 5-10sec of the first detection, the light could work again. If there is no induction signal,
the load should be stopped working within 5-15sec.
Note: when testing in daylight, please turn LUX knob to (SUN) position, otherwise the
EN