28
(a) Remove the touch driver and then install it again.
(b) Execute the “eGalaxTouch utility and check if the interface port is working.
4) When touching the screen, cursor always returns to a fixed position.
(a) Check if there is anything pressing on the touch screen.
(b) Other high power or high frequency equipment may affect the screen or
controller. Make sure that the touch screen is away from the high-voltage
equipment.
(c) The touch screen driver is not installed correctly, install the driver (please
refer to the "Touch Screen Setup") and run a 25-point calibration.
5) Touch screen is not accurate
Run the touch screen calibration program with a 25-point recalibration. We also
recommend doing this after changing the monitor resolution or refresh rate.
When running the calibration, touch the center of calibration point to assure
accuracy.
6) The cursor moves opposite to the touch movement
(a) Run the 4/9/25 point calibration.
(b) The touch screen driver is not installed properly, reinstall the driver.
7) The cursor is fixed at the edge of LCD
(a) Check if the edge of the screen is being pressed by something.
(b) Check the edges of the LCD if there is anything jammed in the front bezel.
(c) Make sure that the touch screen is clean.
8) The cursor in the touch screen can only move in a small area or touch positions
are inaccurate.
(a) This situation usually occurs first time after installing the driver. Please run
the touch screen calibration program. We also recommend you to do this
after changing monitor resolution.
(b) Run the touch screen calibration program to do a 25-point recalibration.
