Bematech LV3000U, Manual

Page: 16 / 19

16
5. Q & A
Q:
How I can clone or extend screen mode?
A: Open the ”Display Properties” window and select the “Settings” tab,
Q: How can I remove the “USB Monitor Installation Program” completely?
A: Click “Add/Remove Programs” in the “Control Panel”. A list of “currently
installed programs” is displayed.
Select “DisplayLink Graphics” from the list and click “Remove”.
Q: The screen size of the USB monitor is larger than the actual monitor size.
A: If the primary monitor has a high resolution, screens are expanded beyond
the recommended resolution in Clone mode (USB monitor).
Q: The screen size of the USB monitor is smaller than the actual monitor size.
The screen is centered on the monitor.
A: If the primary monitor has a high resolution, screens are smaller than the
recommended resolution in Clone mode (USB monitor).
Q: I disconnected or turned off my USB monitor but my PC still displays the old
monitor information in the Display Properties window.
A: The deactivated USB monitors are such that the power to them is turned off
or their USB cables are disconnected. To remove this information, you have to
remove the “DisplayLink Graphics” program from “Add/Remove Programs” in
the “Control Panel”.
If you remove the program you cannot use all the connected USB monitors.
If you want to use the USB monitor again, you have to setup the installation
program again.
Q: Icons and photos are broken or jagged in Clone mode (USB monitor).
A: This occurs because Windows does not send the screen updating information
to Clone mode if Extended mode is active on a single PC. We recommend
using the monitor in Extend mode.
Note Before calling for assistance, check the information in this section to see if you
can remedy any problems yourself. If you do need assistance, please call the phone
number on the In-formation section or contact your dealer.