Quick Start Guide for LS9000 Kitchen Video Controller
9
SYSTEM SETUP
1 Install the LS9000 units as described in HARDWARE INSTALLATION section.
2 Setup optional parameters on LS9000 if necessary (for example: operation
mode, RS232 baud rate, video training folder, etc).
3 Setup the LS9000 station address used for quick identification of the station.
4 Setup LS9000 IP address, subnet mask and port number to the required
values. Check with system administrator for proper settings. Note that the IP
address must match the IP group of the host server and the TCP port address
must match the port number used by the application software.
5. Save parameters and exit setup.
6 Verify that the values on the boot up screen shows the correct set up values. If
not, repeat step 2 to 5 to correct the settings.
7
The setup for one LS9000 is now completed. Repeat as necessary for each
LS9000 in the system, ensuring a unique IP address for each LS9000 (if static
IP address is being used). Always verify the setting on the boot up screen.
8. Check the host server IP address to make sure that it’s in the same IP group as
the LS9000 units. Setup the server IP address if necessary.
9. Setup the application software if necessary, including TCP port number setting.
10. Run the application software or a test program to verify functions of the system.