REPROGRAMMING THE CONTROLS/
ADJUSTING THE MODE
Five different modes with various functions are
available to regulate the lamp.
Mode
Function
Mode 1
No daylight regulation:
the light sensor is switched off.
Mode 2
No movement detection:
the movement sensor is switched off.
Mode 3
No daylight regulation and no move-
ment detection: both light and move-
ment sensors are switched off.
Mode 4
Standby.
Mode 5
Automatic control mode
(factory setting): both light and
movement sensors are activated.
To adjust the mode, proceed as follows:
1. Disconnect the lamp from the mains.
2. Press the switch and hold.
3. Connect the lamp to the mains
(keep the switch pressed down).
The lamp flashes
1x = Mode 1
2x = Mode 2
3x = Mode 3
4x = Mode 4
5x = Mode 5
Release the switch as soon as the desired
mode has been reached. The number of flashes
indicates the set mode. The mode is automati-
cally activated after approx. 10 seconds.
TROUBLESHOOTING
Possible cause
> Solution
1. The lamp is not emitting light
The display diode does not light up:
no power is being sent to the lamp.
> Make sure the lamp is plugged in
and switched on.
> Check the safety fuse (fuse box).
The display diode lights up:
the light was switched off using the switch.
> Press the switch briefly to turn on the light.
The lamp is receiving too much ambient light
and has switched itself off.
> See «Programming light intensity».
> Cover the light sensor for at least 2 minutes.
The lamp does not detect movement.
> Position the lamp so that the sensor can
detect movement (area of 4 x 4m).
The light source is defective.
> Replace the light source.
2. The lamp does not maintain the set value
The desired setting has not been saved.
> See «Programming light intensity».
If you detect any other malfunctions, please
contact your BELUX specialist dealer.
