Reference Manual
Capacitor Bank Protect. Relay KSR1
Rev. 10
2018-09
9
3.4.3
Input of numerical values
For configuration purpose, the input of values is required. By doing this, the routine is always the same, which is why
the following section describes the necessary steps in general.
A preset-value will be displayed with the first (highest) digit blinking. This digit can be changed by using the keys
and
. In order to change to the next (smaller) digit the button
must be pressed. Now, the next digit blinks and its value
can be altered in the same way as before. When arriving the last digit, press the
key once more. This position allows
to set multipliers M (Mega) or k (kilo). To store the value, press the
key once more, and the new value will be saved
and used.
For the case, that an adjusted value cannot be stored another value is shown after confirmation with button
. A
possible reason can be that the entered value is outside of the allowed range. Information about the input ranges is
given in the table on the penultimate page of this document.
At any time, one can go back to the menu he came from without changing the value by pressing the
key. In this case,
the modified value will not be used!