www.belson.com
General Use and Information
Assembly Instructions
NOTE:
All drilling will require a 13/64” bit. * = Specify Color Option
Step 1.
Insert the SAN1-0005 - Dispensing Pipe into the SAN1-0001G - Base.
Step 2.
Line up the pre-drilled holes of the base and dispensing pipe. Insert
a PC-000762 - Locking Rod through the holes of the base and dispensing pipe
and push through to the other side. Place a PC-000205M - Lock onto the lock-
ing rod and secure in place.
NOTE:
The suggested positioning of the Dispenser Holders would be with the
Foam Dispensers in opposition of each other (the top two dispensers opposite
the bottom two dispensers).
Step 3.
Place the SAN1-0004*BC - Bottom Foam Dispenser Holder
(the holder
with a hole through the center)
onto the dispensing pipe, lining up the corners
of the holder with the corners of the base
.
Step 4.
Place the SAN1-0004*TC - Top Foam Dispenser Holder onto the dis-
pensing pipe,
(the holder with a center hole at the bottom)
lining up the corners
of the holder with the corners of the base
pipe).
Step 5.
While pushing down on the top of the holder, drive (2) PC-000158 Self-
Tapping Screws through the two drill spots located along the top of the holder
and through the dispensing pipe.
Step 6.
ts up against the bottom of the
top holder
(with the foam dispensers opposite as suggested).
Drive (2) PC-000158
Self-Tapping Screws through the two drill spots located along the top of the
holder and through the dispensing pipe.
Filling a Dispenser:
ll a dispenser, push up on the tab from underneath the dispenser and pull
down the cover. Fill with
Rid-It™
-
Foam Hand Sanitizer
(follow the instructions
located on the sticker inside of the foam dispenser).
Order Part #FD1-0001 for a
lls, available from PolyJohn.
Filling the Base:
ll the base with water or sand
(in order to create enough ballast to keep from
being tipped over)
, unlock the lock from the base and remove the lock, locking
rod and dispensing pipe. Fill with either water or sand and reinsert the dis-
pensing pipe, locking rod and lock.
NOTE:
lling with sand, make sure to tilt the base on its side to keep the bottom
raised area free from sand for proper re-installation of the dispensing pipe into the base.
Draining the Base:
lled with water, simply loosen the PC-000554 Plug located
nished draining. If
lled with sand, unlock the lock, remove the lock and locking rod and pull out
the dispensing pipe. Turn the base upside down and empty. Reinsert the dis-
pensing pipe, locking rod and lock when empty.