6
7
003
01
RECYCLED PLASTIC PARK MASTER ASSEMBLY
INSTRUCTIONS (CONTINUED)
10.- Attach Brace to angle on Leg
using 1” bolts/nuts. Hand fasten nut.
11.- Attach loose end
of Brace to Center Bracket center hole using 1” bolt/nut.
Note: Do not fully tighten
any of the nuts from steps
10-11 until step 16 below.
12.- Flip the partial table assembly into an upright position.
13.- Slide Back Rail onto Seat Bracket aligning holes with Seat Brackets back holes. Then slide Front Rail onto Seat Bracket
aligning holes with Seat Bracket front holes. Angled edges should butt up against each other as shown.
14.- Insert 2-1/4” carriage bolts through Seat Boards (boards with 4 miters) best face. Then attach Seat Boards to frame as shown.
15.- Bolt Back and Front Rails together using 3/4” bolts / nuts (4 places). Tighten 1-1/4” screws in place as shown.
16.- Tighten all nuts firmly, including assembled parts in steps 10 and 11.
17.- The Picnic Table is finished.
Front
Hole
Front Rail
Short Tab
Back Rail
Long Tab
Back
Hole
1-1/4” Screws
Front Rail
Short Tab
Back Rail
Long Tab
