www.belson.com
FIG #1:
IN ORDER TO MAKE THE ASSEMBLY OF THIS SILHOUETTE
BENCH EASIER WHILE GOING THROUGH THE ASSEMBLY
PROCESS THE BOARD POSITIONS ARE NUMBERED AND
WILL BE REFERENCED IN LATER STEPS.
STEP #1:
STAND ( 1 ) ONE BENCH END UP RIGHT AND PLACE ( 1 ) ONE BULL-NOSED BENCH BOARD ( B ) ON
POSITION 1, BEING SURE TO ALIGN THE PILOT HOLES TO THE PRE-DRILLED HOLES IN THE BENCH
END. AFTER THE HOLES ARE PROPERLY ALIGNED, FASTEN WITH ( 1 ) ONE #12 X 1-1/2” PAN HEAD
PHILLIPS SCREW IN THE PRE-DRILLED HOLE ON THE RIGHT SIDE OF THE BENCH END.
NOTE: DO NOT TIGHTEN SCREW COMPLETELY. THIS WILL BE DONE IN A LATER STEP.
#12 X 1-1/2” PAN
HEAD PHILLIPS SCREW
NOTE: STAND BENCH ENDS FLAT
ON GROUND. VIEW IS ONLY TO
SHOW DETAIL.
