7
Basic Operation
Preparing for Use
Before you can use your cordless telephone, you must charge the
HANDSET
for 12 hours. Failure
to do so will require recharging of the BATTERY PACK more often.
1.
Place the
HANDSET
on the
BASE UNIT
for 12 hours.
2.
After 12 hours, remove the
HANDSET
from the
BASE UNIT
.
Before you can use your cordless telephone, you must charge the HANDSET for 12
hours. Failure to do so will require more frequent charging of the BATTERY PACK.
See page 11 for more information on the BATTERY PACK.
NOTE:
Depending on the frequency of use, once the
HANDSET
is fully charged, it remains functional for
approximately 4 hours of continuous use and approximately 5 days when the
HANDSET
is off the
BASE UNIT
in STANDBY mode.
Placing Calls
1.
Press the button. The IN USE LED
indicator will light up.
2.
Listen for a dial tone.
3.
Dial the phone number.
4.
When you have finished your call, press the
button again. The IN USE LED indicator
will turn off.
NOTES:
1.
The
BASE UNIT
does not have a ringer and does not ring when receiving an incoming call.
2.
If you are too far away from the
BASE UNIT
, the
HANDSET
emits “beep” sounds to warn you
that the background noise level is too high for proper communication between the
HANDSET
and the
BASE UNIT
. When you hear this sound, you should move closer to the
BASE UNIT
to
reduce the noise level. Otherwise, the call will automatically cut off.
TALK
SCAN
REDIAL
IMPORTANT
When you hear interference, press the
button to change the operating channel.
