Fig. 1
DSYF14
DSYF2
4X
DSYF9
2X
DSYF18
DSYF17
DSYF16
1. On a very SOFT and flat surface,
CAREFULLY LAY
the two
curved Wood Sides (DSYF17, DSYF18) face down and
approximately 52 inches apart from one another.
Note (!): Pay close attention to the position of each Wood Side
in regards to its Part Number, and position as shown in Fig. 1.
The holes in the side edges of each panel should face toward
the
center
of the stand.
2.
ATTACH
the Bottom Wood Frame (DSYF16) as shown using
two sets of Cam Pins with Cam Locks (DSYF9).
SCREW
the
Cam Pins into the prethreaded holes in the curved Wood Sides
(DSYF17, DSYF18).
INSERT
the Cam Locks into the large holes
in the Bottom Wood Frame with the openings facing the Cam
Pins.
INSERT
the Cam Pins into the Cam Locks and turn Locks
to tighten.
3.
ATTACH
the Top Shelf Rear Support Bar (DSYF14) to the
curved Wood Sides (DSYF17, DSYF18) using four 15 mm
Screws (DSYF2) as shown.
(!)
(!)
assEMBLY iNstrUCtiONs
NOTE:
2 PEOPLE ARE RECOMMENDED TO ASSEMBLE THIS FURNITURE. TO AVOID DAMAGE DURING ASSEMBLY, IT SHOULD BE ASSEMBLED ON A
SOFT SURFACE.
