1.5V AAA
Getting started
1
Open the battery cover, fit the battery and close the cover again.
Attach the pager to your belt using the belt clip. For extra security, use the supplied safety cord.
2
To test the radio link you need a Visit transmitter. Press the test button/s on the transmitter.
3
The pager starts to vibrate and lights up a Visit LED. If a bed shaker is connected during charging, it will vibrate.
If nothing happens, see
Troubleshooting
.
1
2
3
Default signal pattern
When a transmitter is activated, the pager lights up an LED and starts to vibrate with a certain pace. This is called signal
pattern. The transmitters determine the pattern, and the default is as follows:
Activated transmitter
Pager LED
Pager / bed shaker vibration
Door transmitter
Green Slow
Push button transmitter Green
Slow
Telephone transmitter
Yellow
Medium
Baby monitor
Orange
Fast
Smoke alarm
Red
Long
Changing the signal pattern
The signal pattern can only be changed on the transmitters. See
Changing the signal pattern
for the relevant transmitter.
Changing the front label
If you want to use Visit for other purposes, the pager front label can be replaced with a customized one. Here is how it’s done:
Open the battery cover, replace the original label with the supplied extra label and close the cover again.
Replacing the battery
When the battery LED starts to blink in yellow, the battery is nearly depleted. Here is how you replace it:
Open the battery cover and press the battery eject button to remove the old battery. Insert a 1.5 V AAA alkaline battery
or a 1.2 V AAA NiMH rechargeable battery if you are using the BE1260 charger accessory.
Visit pager receiver
