for personal safety:
DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIANCE.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE
FROM THE POWER CORD.
EARTHING
CONNECTION
Improper connection of the equipment earthing conductor can result in the risk of an
electric shock.
Check with a qualified electrician or service representative if you are in doubt whether the
appliance is properly earthed.
Do not modify the plug provided with the appliance. If the plug does not fit properly to the
outlet, please have a qualified electrician to install a proper outlet.
Insert the drain hose into a d rain pipe with a minimum diameter of 4 cm, or le t it r un into the si nk, m aking sure to
avo id bending o r crimping. Use the special plastic support that com es with the appliance. The top of the hose
must be at a height between 40 and 100cm.Th e free end of the hose must not be immersed in wat er.
A hose that attaches to a sink spray can burst if it is in stalled on the same water line as the d ishwash er. If your sink
has one, it is recommended that the hose be d isco nnected and the hole plu gged.
Pull The safety supply hoses completely out from storage compartment located at rear of dishwasher.
Turn water fully on before starting the dishwasher.
1
Tighter the screws of the safety supply hose to the faucet with thread 3/4inch.
Th e sa fety supp ly hose consists of the double wa lls. T he hose's sy stem guaran tees its intervention by b lock ing the
flow of wate r in case of the supply ho se b reaking and whe n the air spa ce b etween the supply hose itself and the oute r
corruga ted hose is full of water.
Turn off the water.
Release the water pressure by depressing the pressure release button. This relieves water pressure and protects you, and the
room, from severe splashing.
Unscrew the safety supply hose from the faucet.
3
2
1
2
3
Th e appliance mus t be connected to the water mains using new hose-sets.
Th e old hose-sets should not be reused.
Water pressure must b e between 0,04 MPa and 1 M Pa. If the pressu re is below the
minimum consult our Service Department fo r advice.
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fastened tightly in place.
If the water pipe s are new or have not been used for an extended period of time, let the water run to ma ke sure that the
water is clear and free of impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked
and damage the appliance.