Belling 60ICH SIL, Installation & User'S Instructions, Page: 7 / 12

7
to remove by carefully pulling down and out of the hood.
2. Place the charcoal filter on the centre of the motor support and when firmly located turn
clockwise 90° (¼ of a turn) until the “Stop” click is heard to lock it in position.
3. Carefully replace grille.
• Electrical Connection
Before connecting to the mains supply ensure that the voltage is as stated on the rating
plate inside the cooker hood.
Warning: This appliance is fully insulated and must not be earthed.
The appliance comes with a 2 core mains cable and should be permanently connected to
the electricity supply via a double pole switched fused spur outlet with a minimum contact
clearance of 3mm in both poles.
Installation must comply with the latest IEE regulations and must be carried out by a
competent person.
The cooker hood must be protected by a 3-amp fuse.
•
Use and Maintenance
It is advisable to switch the cooker hood on a few minutes before cooking starts and that it
be left on for about 15 minutes after cooking is completed to exhaust all the odours.
On the inner right side of the hood will be found:
a) Light switch - for manual or automatic control.
b) Exhaust fan speed control switch - 3 speed and 0ff. For manual or automatic control.
c) Cooker hood “On” indicator red light.
Good functioning of the hood depends on the regularity with which maintenance operations
are carried out, in particular of the anti-grease filters and the activated charcoal filter. The
anti-grease filters have the function of holding back grease
particles suspended in the air, and are thus subject to clogging with time depending on the
frequency of use of the appliance.
Warning: For your own safety always switch off your cooker hood at the mains
supply before opening and removing the grille assembly.
1. To gain access first remove grille (see Fig.2) by taking hold of knob Y and carefully
lifting the grille up and out of groove behind which it is retained. The grille is then
completely free to remove by carefully pulling down and out of the hood.
Unfasten slide brackets either side of grille and hinge grille down (see Fig.4).
2. Remove the grease filter fixing clamps.
1. Carefully extract the synthetic grease filter which should then be washed by hand in
lukewarm water and liquid detergent at least once a fortnight. When clean squeeze
gently, but do not wring it out.
2. Before replacing the synthetic grease filter, clean the holder in a warm detergent
solution or with a damp cloth. Then replace the synthetic grease filter when dry.
5. The inside and outside of the hood may also be cleaned with a damp cloth and/or
warm soapy water.
Note: Never use abrasives!
The hood must not be used without the grease filter.