Installing Your Cooker
Environmental Protection
We are committed to protecting the environment and operate an Environmental Management
System which complies with BS EN ISO 14001.
Disposal of packaging
n
All our packaging materials are recyclable and environmentally friendly.
n
Please help us to protect our environment by disposing of all packaging in an environ-
mentally friendly manner.
n
Please contact your local authority for the nearest recycling centre.
CCaauuttiioonn::
Packaging materials can pose a risk of suffocation - keep away from children.
600 installation built in (high level) and built under (low level)
Remove the fixing screws from the polythene bag on the top of the appliance, but leave the
appliance in the base tray packaging until you are ready to install it.
Note:
When removing the appliance from the base tray packaging care should be taken not
to damage the appliance.
1. When installing in a typical 600mm deep,
built in housing unit, the false back should be
removed from the housing unit to provide
the necessary depth for installation.
2. When the false back is removed, it is normal-
ly the case that the support shelf for the
appliance leaves a gap between the back
edge and the wall of approximately 80mm.
3. If no gap occurs between the back edge of
the shelf and the wall behind the unit, we
recommend that a gap of at least 30mm is
made by shortening the shelf.
The appliance is designed to fit into a standard 600mm wide housing unit, with minimum
internal dimensions as shown.
Note:
590mm is to the underside of the worktop when the appliance is built under, or to the
underside of the panel above, when the appliance is installed into a tall housing unit.
Please note that all sizes are nominal, and some variation is to be expected.
Installing appliance under a worktop
Where the appliance is installed under a worktop, with a hob installed above it, the instal-
lation instructions for the hob must be read in conjunction with these instructions.
39
Front
of oven
Back edge of
support shelf
30-80
mm
12mm
gap
Rear
Wall
