Bellfires DERBY SMALL 3, Instructions For Use & Manual Daily Maintenance

Page: 12 / 112

12
Bell  res
English
Instructions for use
Figure 2: Receiver “RESET” button
Set the display
• Connect the batteries. By simultaneously pressing OFF and (small ! ame), can be
switched from °F (and 12 hour clock) to °C (and 24 hour clock), or vice versa.
• The display will automatically return to
mode after some time, but you may
immediately return to mode by pressing the OFF button.
Set the current time
• By simultaneously pressing (large ! ame) and (small ! ame), the display ! ashes.
You are in SET mode.
• While the screen is ! ashing, you can adjust the time.
• Press (large ! ame) to set the hour and (small ! ame) to set the minute.
• Wait or press
OFF to return to mode.
Important: Setting up signal code before using the appliance for the ! rst time.
Before the appliance can be used, the receiver must " rst learn the hand-held
transmitter’s signal code.
• Press the “ RESET ” button on the receiver, and keep this pressed until 2 audio signals
are heard. See " gure 2.
Release the “
RESET ” button after the second (somewhat longer) audio signal.
• Press, within 20 seconds, the (small ! ame) button on the hand-held transmitter,
until 2 short signals are heard. The signal code has now been set up on the receiver .
If, however, a single long sound is heard, this means that setting the signal code has
failed or that the wiring has been connected incorrectly.
You only need to set up the signal code once. It is not necessary when changing the
batteries of the hand-held transmitter or receiver.