Bellfires DERBY LARGE 3 CF - LF, Instructions For Use & Manual Daily Maintenance, Page: 14 / 28

14
Bell fi res
English
Instructions for use
Set the current time
• The time display will fl ash after either:
a installing the battery or
b simultaneously pressing the (large fl ame) and
(small fl ame).
• While the screen is fl ashing, you can adjust the time.
• Press (large fl ame) to set the hour and (small fl ame)
to set the minute.
• Wait or press
OFF to return to mode.
Set the display - °C/24 hour or °F/12 hour Clock setting
• Connect the batteries. By simultaneously pressing OFF and
(small fl ame), can be switched from °F (and 12 hour clock)
to °C (and 24 hour clock), or vice versa.
• The display will automatically return to mode after some
time, but you may immediately return to mode by
pressing the OFF button.
Important: Setting up signal code before using the appliance for the fi rst time.
Before the appliance can be used, the receiver must fi rst learn the hand-held
transmitter’s signal code.
• Press the “ RESET ” button on the receiver, and keep this pressed until 2 audio signals
are heard. See fi gure 3.
Release the “
RESET ” button after the second (somewhat longer) audio signal.
• Press, within 20 seconds, the (small fl ame) button on the hand-held transmitter,
until 2 short signals are heard. The signal code has now been set up on the receiver .
If, however, a single long sound is heard, this means that setting the signal code has
failed or that the wiring has been connected incorrectly.
You only need to set up the signal code once. It is not necessary when changing the
batteries of the hand-held transmitter or receiver.