CHARGING
1.
Make sure the adapter and telephone line cord is connected to the Excursion
®
39606.
2.
Place the handset on the base cradle. The CHG (Charge) LED indicator of the base unit
will light steadily.
3.
Leave the handset charging on the base for 14 hours continuously to get a maximum
charge.
4.
The Excursion
®
39606 is now ready for regular use. Discharge and charge the Ni-Cd
battery again once you notice a decrease in the useable charge time.
MAINTENANCE
1.
Your phone should be situated away from heat sources such as radiators, heaters,
stoves or any other appliance that produces heat.
2.
Use a slightly damp cloth to clean the plastic cabinet. A mild soap will help to remove
grease or oil. Never use polish,
solvents, abrasives or strong detergents since these can
damage the finish.
TROUBLESHOOTING
SYMPTOMS
POSSIBLE SOLUTION / CAUSE
No dial tone
•
Check for the telephone line cord connectors at both ends
that they are pushed in firmly until they click.
•
If you had a power failure or had unplugged the base unit,
replace the handset on the base unit for two to five seconds
to reset the system.
Does not ring
•
Check the RING ON/OFF switch on the handset. Switch to
the RING ON position to enable the handset ringer.
•
Check for the telephone line cord connectors at both ends
that they are pushed in firmly until they click.
•
You may have exceeded the Ringer Equivalence Number
(REN) limit of how many phones can be connected to the
same line. The REN total of all devices (printed on the bottom
label of each unit) should not exceed five (5). Disconnect the
appropriate units to lower the REN total.
No power on the
handset unit
•
Check for the Ni-Cd battery pack for proper connection inside
the battery compartment on the handset.
•
The handset rechargeable Ni-Cd battery pack may need
charging.
Does not charge
•
Check for the Ni-Cd battery pack for proper connection inside
the battery compartment on the handset.
•
The charging contacts and terminals may need cleaning with
an alcohol-dampened swab.
Range is limited
•
Raise or reposition the antenna on the base.
•
Move the base unit so that it is centrally located in your
residence or office and make sure that the base unit is not
located near appliances.
•
The handset Ni-Cd battery may be weak. Recharge the
Ni-Cd battery.
•
Refer to the section "Improving Cordless Reception".
Interference on
reception
•
Choose an alternate channel using the SCAN button on the
handset.
•
Refer to the section "Improving Cordless Reception".
Summary of Contents for Excursion 39606
Page 8: ......
