Installation of the PureAV Isolator
Pur
eA
V Is
olat
or
1) Turn OFF all of your electronic equipment and ensure that the PureAV
Isolator is also switched OFF.
2) Plug your electronic devices into the Isolator’s AC outlets.
Note: DO NOT USE two-wire extension cords or adapters with this
product. Using any extension cord in conjunction with the Belkin
PureAV Isolator will void all Belkin Corporation warranties. All
connected equipment should be plugged directly into your Belkin
PureAV Isolator.
3) Satellite Components: Connect the coaxial cable line from the satellite
source to the Isolator’s satellite connector marked “IN”. Use a second
coaxial cable to connect the Isolator’s cable connector marked “OUT” to
the appropriate input on your satellite device.
4) Coaxial/Antenna: Connect the coaxial cable line from the cable/antenna
source to the Isolator’s cable/antenna connector marked “IN”. Use a
second coaxial cable to connect the Isolator’s cable/antenna marked
“OUT” to the appropriate input on your cable or antenna device.
5) Phone/Fax/Modem Data Connections: Connect a modular phone cord
from the wall jack to the Isolator’s phone jack marked “IN”. Use a
second modular phone cord to connect to the phone line jack marked
“IN” on the phone to the Isolator’s phone jack marked “OUT”.
[Each PureAV Isolator model comes with solid-state, phone/fax/modem,
Internet-ready (RJ11 jack) surge protection with a built-in phone line splitter.]
If desired, use a third modular phone cord and connect your computer
modem data line jack marked “IN” with the Isolator’s other phone jack
marked “OUT”. Or you can connect a second data line device of your
choice (fax, etc.).
Note:
If you fail to connect the phone/fax/modem protection, the
Connected Equipment Warranty will not cover your connected
equipment with telecom ports. Most modem damage can be prevented
if you take the time to connect the phone/fax/modem protection.
6) Your PureAv Isolator should be plugged into a grounded wall outlet
(3-conductor, 120V AC/60Hz) only.
2
