Belkin
Setup
completed
installation,
but
I
cannot
browse
the
Web.
The
light
on
the
front
of
my
Router
is
blinking
amber.
1)
Make
sure
the
Router
is
connected
to
your
modem
with
an
Ethernet
cable
via
the
Router’s
one
WAN
(modem)
port.
2)
Unplug
the
modem
from
its
power
source
and
make
sure
that
it
goes
dark.
Then
reapply
power
to
the
modem.
3)
Unplug
your
Router’s
power
supply,
wait
10
seconds,
and
plug
it
back
in.
This
will
cause
the
Router
to
try
to
reestablish
communication
with
the
modem.
Belkin
Setup
completed
installation,
but
I
cannot
browse
the
Web.
The
light
on
the
front
of
my
Router
is
solid
amber.
1) Use the troubleshooting suggestions within Belkin Setup.
2)
If your ISP requires a user name and password, make sure
that you have typed in your user name and password
correctly. Some user names require that the ISP’s domain
may be at the end of the name. Example:
“[email protected]”. The “@myisp.com” part of the
user name may need to be typed as well as your user name.
3)
If you have a static connection, your ISP will have assigned
you an IP address, subnet mask, and gateway address.
Please re-run Belkin Setup and enter this information when
a static connection is mentioned.
4)
You may need to configure your Router to meet the
specific requirements of your ISP. To search our
knowledge base for ISP-specific issues, go to:
http://www.belkin.com/support and type in “ISP”.
5) If you continue to have no Internet connection, refer to
“Manually Configuring Network Settings” in this manual for
an alternative setup method.
I
can’t
connect
to
the
Internet
wirelessly.
If
the
light
on
the
front
of
the
Router
is
solid
blue,
then
your
Router
is
connected
to
the
Internet.
You
may
not
be
connected
to
the
