Installation | 03
Important Note:
Please do not connect any USB devices to the Hub until instructed to
do so in step 5 of this installation procedure.
1.
Position your Hub in a desired location at the edge of your desk or table, or around a
cable bundle.
WARNING:
The Hub’s clip has a one-inch tolerance. Opening the clip mechanism
beyond this may damage the unit. Please use caution not to strain or exceed the clip
limits.
2.
Plug the AC adapter into a wall outlet or surge protector. Plug the DC connector into
the DC power jack found on the rear of the Hub.
Note:
The Hub may be used without the power supply when connecting low-power
devices such as keyboards and mice.
3.
Plug the flat end of the provided USB device cable into the downstream port of your
computer, or downstream port of another hub, then plug the mini-USB connector on
the device cable into the upstream port on the rear of the Hub.
Important Note:
The Hub must be connected to a USB 2.0-compliant host in order
to function in high-speed mode (480Mbps data rate). If the Hub is connected to
a USB 1.1-compliant host, it will operate only in low-speed or full-speed mode
(1.5Mbps/12Mbps).
Installation
Summary of Contents for F5U416 - Clip-On Hub
Page 1: ...Introduction User Manual USB Clip On Hub...
Page 2: ......