16
Belkin
®
Advanced Secure 8-Port and 16-Port DVI-I KVM User Manual
oPeraTInG THe KVM swITCH
SECTIONS
operation
self-Test Procedure:
As product powers-up it performs a self-test procedure. In case of
self- test failure for any reason, including jammed buttons, the product
will be Inoperable. Self-test failure will be indicated by the following
abnormal LED behavior:
• All channel-select LEDs will be turned ON and then OFF;
• A specific, predefined LED combination will be turned ON;
• The predefined LED combination will indicate the problem type
(jammed buttons, firmware integrity).
Try to power cycle product. If problem persists please contact your
system administrator or technical support.
Now that product, computers and peripherals are connected and
powered up, it is ready for use.
selecting a Computer using Port selectors
Now that you have connected your console and computers to the
Switch, it is ready for use. You can select which computer you wish to
control by pressing the corresponding port selector on the front of the
Switch. The LED number will illuminate to indicate which computer (or
port) is currently selected. It may take approximately 1 second for the
video signal to sync after switching ports. This is normal behavior and
is dependent on the display connected. This is normal operation and
ensures that proper synchronization is established between the monitor
and the connected computers.
Keyboard and mouse inputs can only be sent to the selected computer,
and video outputs can only be received from the selected computer. The
Switch also prevents any data transfer between connected computers,
ensuring the security of your computers.
Please note
that the default port at power-up is port 1. In case of a
power failure or if the power is cycled, the Switch will default to port 1.
