Belden HIRSCHMANN SPIDER II, User Manual

Page: 23 / 36

Installation SPIDER II
Release 07 10/2013
23

Mount the terminal block for the supply voltage and the ground
connection.
Connecting the voltage supply via the terminal block starts the operation of
the device.
2.6 Connecting network cables
Note:
Verify that you connect solely optical ports with the same optical
transmission properties with each other.
You can connect terminal devices and other segments on the ports of the
device via twisted pair cables or F/O cables.
2.6.1 10/100 Mbit/s twisted pair port
You will find further information under “10/100 Mbit/s twisted pair port” on
page 15 .

Install the data lines according to your requirements.
2.6.2 10/100 Mbit/s PoE port
You will find further information under “10/100 Mbit/s PoE port” on page 15 .

Install the data lines according to your requirements.
2.6.3 10/100/1000 Mbit/s twisted pair port
You will find further information under “10/100/1000 Mbit/s twisted pair port”
on page 16 .

Install the data lines according to your requirements.
2.6.4 100 Mbit/s F/O port
You will find further information under “100 Mbit/s F/O port” on page 16 .

Install the data lines according to your requirements.
2.6.5 1000 Mbit/s F/O port
You will find further information under “1000 Mbit/s F/O port” on page 17 .

Install the data lines according to your requirements.