Status
3.3 Network Status
Continued from previous page
Item
Description
TX
•
packets
– transmit packets
•
errors
– number of errors
•
dropped
– dropped packets
•
overruns
– outgoing packets lost because of overload.
•
carrier
– wrong outgoing packets with errors resulting from the
physical layer.
collisions
Number of collisions on physical layer.
txqueuelen
Length of buffer (queue) of the network interface.
RX bytes
Total number of received bytes.
TX bytes
Total number of transmitted bytes.
Table 9: Description of Information in Network Status
You may view the status of the mobile network connection on the network status screen. If
the connection to the mobile network is active, it will appear in the system information as an
usb0 interface.
The
Route Table
is displayed at the bottom of the
Network Status
page. There is IPv4
Route
Table
and
IPv6 Route Table
below.
If the router is connected to the Internet (a default route is defined), the
nat64
network interface
is created automatically. This is the NAT64 internal gateway for translating the IPv6 and IPv4
communication. It is used automatically when connected via IPv6 and communicating with IPv4
device or network. It works together with DNS64 running in the router automatically (translation
of domain names to IP addresses). The default NAT64 prefix 64:ff9b::/96 is used as you can
see in Figure
below in the
IPv6 Route Table
section.
UM Configuration OWL LTE M12
Rel. 06.1.09 - 07/2019
23
Summary of Contents for Hirschmann OWL LTE M12
Page 153: ......
