Installation BAT-R
Release 17 12/2020
31
1.5.1
Gigabit combo port
You have the option of alternatively connecting a twisted pair cable via a
RJ45 socket or an optical fiber via a SFP transceiver to a combo port.
Only plug a connector or SFP transceiver that you want to use for the data
transmission into the socket of the combo port.
10/100/1000 Mbit/s PoE PD port
Only device variants featuring supply voltage with characteristic value W
(24 V DC) have this port.
The 10/100/1000 Mbit/s PoE PD port offers you the ability to connect
network components according to the IEEE 802.3 10BASE-T/100BASE-
TX/1000BASE-T and IEEE 802.3af/at standard.
This port supports:
Autocrossing (if autonegotiation is activated)
Autonegotiation
Autopolarity
10 Mbit/s half-duplex mode, 10 Mbit/s full duplex mode
100 Mbit/s half-duplex mode, 100 Mbit/s full duplex mode
1000 Mbit/s full duplex
Delivery state: Autonegotiation activated
The port casing is electrically connected to the front panel.
The pin assignment corresponds to MDI-X.
When using 10/100 Mbit/s, the PoE power is supplied via the signal-
transmitting wire pair (phantom voltage) or via the free wire pairs (spare
pair supply).
10/100/1000 Mbit/s twisted pair port
Only device variants featuring supply voltage with characteristic value C
(24 V DC ... 48 V DC) or K (60 V DC ... 250 V DC / 110 V AC ...
230 V AC, 50 Hz ... 60 Hz) have this port.
The 10/100/1000 Mbit/s twisted pair port allows you to connect network
components according to the IEEE 802.3 10BASE-T/100BASE-TX/
1000BASE-T standard.
This port supports:
Autocrossing (if autonegotiation is activated)
Autonegotiation
Autopolarity
10 Mbit/s half-duplex mode, 10 Mbit/s full duplex mode
100 Mbit/s half-duplex mode, 100 Mbit/s full duplex mode
1000 Mbit/s full duplex
Delivery state: Autonegotiation activated
The port casing is electrically connected to the front panel.
The pin assignment corresponds to MDI-X.
