18
MIPP
Release 01 01/12
2.3
Installing the device and grounding
2.3.1
Mounting on the DIN rail
You have the option of assembling the device on a 35 mm DIN rail according
to DIN EN 60175.
No tools are necessary.
Proceed as follows:
Install the slider into the DIN rail
.
Press the device down against the DIN rail until it locks in.
Fix the ground cable (not included in the delivery) with one end on the
ground connection of the module and the other end to the ground bar of
the installation system.
Figure 12: Assembling the device on the DIN rail
2.3.2
Mounting on the wall mounting plate
You have the option of mounting the device on a wall or on another level
surface. Use the wall mounting plate for this.
You will require the following tools (not included in the delivery):
Cross-tip screwdriver
Drill
4 Screws
4 Screw anchors that match the screws
Prepare the following device components:
1 Wall mounting plate with the respective length (a total of 30 mm per
single module, 60 mm per double module; see
page 23 “Accessories and order numbers”
)
1
2
Summary of Contents for Hirschmann MIPP
Page 26: ......
