7: Administration
UM Configuration BAT-C2
125
Release 01.0.00 04/2019
Gateway
The BAT-C2 can be configured as a wireless router with DHCP server functionality.
Status
This page displays the current configuration and statistics information for the gateway.
To view gateway status: on the
Administration
page, click
Gateway > Status
.
WAN
When operating as a gateway or router, BAT-C2 offers multiple options for selecting the WAN
interface to use in these modes. See
for WAN Configuration options.
Gateway Settings
Description
Operating Mode
Select the type of operating mode:
Disabled
: prevents the BAT-C2 to be used as a gateway; use normally
(default).
Gateway
: allows the BAT-C2 to be used as a router with NAT.
Router
: allows the BAT-C2 to be used as a router without NAT.
Firewall
Select to enable or disable firewall:
Enabled
: enables the gateway firewall.
Disabled
: disable the gateway firewall (default).
MAC Address filter
Select to enable or disable the MAC address filter. Disabled by default.
Interface
Specify the interface with which the gateway will connect to the WAN:
wlan0: connect to WAN via WLAN (default)
eth0: connect to WAN via Ethernet
Note:
When WAN interface is wlan0, the LAN interface is eth0. When
WAN interface is eth0, the LAN interface is Access Point.
IP Address
Assign a static IP address to the gateway.
IPv6 Address
Assign a static IPv6 address to the gateway.
Primary DNS
Enter the IP address of the primary Domain Name Server.
Note:
This setting will be used when either Static IP or Auto IP is active, or
if DHCP/BOOTP is active and no DNS server was acquired from the
server.
Secondary DNS
Enter the IP address of the secondary Domain Name Server.
Note:
This setting will be used when either Static IP or Auto IP is active, or
if DHCP/BOOTP is active and no DNS server was acquired from the
server.
Table 7-5 WAN Configuration
