30
Installation
Installation of the KMX-3921 in a Densité 3+ Frame
Installation of the KMX-3921 in a Densité 3+ Frame
The KMX-3921 multiviewer can be installed in either a Densité 3+ FR1 frame or a
Densité 3+ FR4 frame. The frame must be networked and powered, and configured for use.
To avoid any network IP address conflict, see
Avoiding Networked Equipment IP Address
The KMX-3921 cards are installed in the frame along with its associated rear panel. The rear
panel must be installed in the frame before the card can be inserted into the frame. All
cards and rear panels can be installed with the frame power on. The card has connectors
which plug into a mid-frame mother board for distribution of power and for connection to
the controller card, and a second connector which plugs directly into the rear panel for
input and output connections.
To install a KMX-3921 multiviewer into a Densité 3+ FR1 frame, see
, on page 30. To install a KMX-3921 multiviewer into a
Densité 3+ FR4 frame, see
Installation overview in a Densité 3+ FR4 Frame
Installation overview in a Densité 3+ FR1 Frame
To support a video wall mosaic output, one SFP module must installed in the rear panel. See
KMX-3921 Models and Related Hardware
, on page 14 for a summary of the hardware that
can be installed. See also the
Densité 3+ FR1 Housing Frame User Manual User Manual
for
information about how to install, power up, and configure a Densité 3+ FR1 frame.
Multiviewer with a KMX-3921-9X2-3+SR Rear Panel
The one KMX-3921 card is installed in a Densité 3+ FR1 Frame slot that the
KMX-3921-9X2-3+SR rear panel occupies.
A KMX-3921 Card shown Assembled with a KMX-3921-9X2-3+SR Rear Panel in a Densité 3+ FR1
Frame
KMX-3921-9X2-3+SR Rear Panel
KMX-3921 Modular Card
SFP Output Module
Card Ejector
